JVC GM-P420E Bedienungsanleitung Seite 8

VIDEO
IN OUT
VIDEO A
8 VIDEO A terminals (page 12)*
• VIDEO IN terminal (BNC)
Connect this terminal to the video output terminal of a
VCR, etc.
• VIDEO OUT terminal (BNC)
Connect this terminal to the video input terminal of
another Monitor.
• AUDIO (L/MONO, R) input terminals (pin jack)
Connect these terminals to the audio input terminals of a
VCR, etc.
Note:
• Since the video output terminals on this Monitor are
loop-though terminals, the devices connected to this
video output terminal should be correctly terminated.
Otherwise, pictures become abnormally bright or the
Monitor screen gets affected abnormally.
9 VIDEO B terminals (page 12)*
• Y/C (S video) IN terminal (mini DIN 4pin)
Connect this terminal to the S-video output terminal of a
VCR, etc.
• VIDEO IN terminal (pin jack)
Connect this terminal to the video output terminal of a
VCR, etc.
• AUDIO (L/MONO, R) input terminals (pin jack)
Connect these terminals to the audio output terminals of
a VCR, etc.
Note:
• When both the video and S-video terminals are
connected, the S-video terminal will have priority.
8 9
AUDIO VIDEO
L/MONO
R
IN Y/C IN
VIDEO B
Note:
* GM-P420PCE and GM-P421PCE do not have
the following input terminals—VIDEO A,
VIDEO B, and COMPONENT/RGB B. To
input video, S-video, and component
signals, you need to install video input unit
(IF-C422P1G), which is separately
purchased.
AUDIO
L/MONO
R
Y/G Pb/B Pr/R
COMPONENT/RGB B
p COMPONENT/RGB B input terminals (page 12)*
• R, G, B, HD/Cs, VD (VIDEO) input terminals (BNC)
Connect these terminals to the following output
terminals of a personal computer or other equipment:
– Analog RGB signal output terminals
– Horizontal sync (HD) signal or composite (Cs) signal
output terminal
– Vertical sync (VD) signal output terminal
Notes:
• External sync signals are automatically detected when
they come in.
• When both horizontal (HD)/vertical (VD) sync and
composite (Cs) sync are connected, HD/VD sync signals
will be used.
• Y, Pb, Pr (VIDEO) input terminals (BNC)
Connect these terminals to the component signal output
terminals of NTSC or high-vision equipment.
Note:
• When these terminals are used as the component
terminals (Y, Pb, Pr)—see "Setting the COMPONENT/
RGB B Input" on page 23, external sync signals (HD/Cs,
VD) cannot be used.
• AUDIO (L/MONO, R) input terminals (pin jack)
Connect these terminals to the audio output terminals of
the other equipment.
p
VIDEO AUDIO
L/MONO
R
HD/Cs VD
7