Engb; Before Installing This Navigation Unit; Installation With The Holder And Side Bracket - Pioneer AVIC-HD3-II Installationshandbuch

Installation
Before installing this
navigation unit
% Remove the holder.
Loosen the screws (3 mm × 6 mm) to remove
the holder.
Holder
Screw (3 mm
Installation with the holder
and side bracket
1 Install the holder into the dashboard.
After inserting the holder into the dashboard,
select and bend the tabs appropriate to the
thickness of the dashboard material. (Install
this navigation unit as firmly as possible using
the top and bottom tabs. To secure this naviga-
tion unit, bend the tabs 90 degrees.)
Dashboard
Holder
6 mm)
2 Install this navigation unit and fasten
the screws.
Dashboard
Screw (3 mm
Be sure to attach the rubber bush to the long
end of double-ended screw.
3 Attach the trim ring.
Trim ring
Rubber bush* 1
Double-ended
screw
6 mm)

Engb

Section
03
23