Conrad S3318P Bedienungsanleitung Seite 44


To accelerate recognition, briefly push the button „TX" (16) in the outdoor sensor's
battery compartment.
This manually sends a data package with the measured values.
The transmission LED (14) of the outdoor sensor flashes briefly when a data package
is transferred.
• After completion of the sensor search, the weather station will start a reception attempt for
the DCF signal; the radio tower symbol (H) flashes above the second display.

The search for the DCF signal and assessment of the signal may take up to 10
minutes; do not move the weather station during this time and do not push any button.
Observe the following chapter 10 on DCF reception.
If no current time is displayed even after 10 minutes, place the weather station elsewhere
and search for the DCF signal again.
Keep the button „DOWN/DCF" (3) pushed for about 3 seconds until a sound signal is issued.
After a few seconds, the DCF signal should start to flash.
• While the radio tower icon (H) flashes, DCF reception can be switched off by briefly pushing
the button „DOWN/DCF" (3). The radio tower symbol disappears.
Set the time and date manually. This may be required if reception conditions are bad (e.g.
in a basement room).
44
Signal received, evaluation running
No signal present