On-Screen Menu - WolfVision PSM-10 Bedienungsanleitung

ON-SCREEN MENU

For standard use of the PSM 10 it is not necessary to go into the camera's menu and change settings.
Inexperienced users should not make any adjustments in the on-screen menu.
To enter the on-screen menu press the MENU-key (#19) for 1 second. Settings of the camera's basic
functions can be made here.
To navigate, use the 4 SELECT-keys (=the numerical keys with red arrows - #20).
Please note that the functions of the on-screen, as shown below, may change after a firmware update.
(layout shows firmware v1.03a)
ON-SCREEN MENU - LAYOUT
PSM-10 Menu
Color Settings
White Balance
Color / Contrast Setting
Return
Misc Settings
Detail
Focus Priority
Iris Priority
Digital Zoom
Dig. Zoom Warning
AF Region
IR Code
Return
Power-On Settings
Store Power-On-Preset
Display Logo
Mains-On
Return
Pos/Neg. Mode
Color / B/W
Output Frequency
Reset Complete Menu
EXIT
Please note: If a setting is marked with "!", the setting is changed with the RS-232 control software.
This is only a temporary change, until the camera is disconnected from power. To change a setting
permanently, change the setting in the on-screen menu.
RESET OF ON-SCREEN MENU SETTINGS
All settings in the on-screen menu can be set back to the factory defaults. "Reset" is one item in the on-
screen menu.
-
AUTO-TRACKING
ONE-PUSH
Trigger by pressing the White-key
MANUAL
R Gain +0 (-120 to +120)
G Gain +0 (-120 to +120)
CENTER
POWER-ON
POSITIV
COLOR
Are you sure YES
1
HIGH
AUTO
AUTO
ON
STOP
A
ON
60Hz
NO
5
(0, 2)
(OFF, MEDIUM)
(MANUAL)
(MANUAL)
(OFF)
(MESSAGE, NONE)
(LARGE)
(B, C, D)
(OFF)
(STANDBY)
(NEGATIVE)
(BLACK/WHITE)
(75Hz)