Siemens SCALANCE W784-1 Betriebsanleitung Seite 68

Description
3.3 LED display
LED Color
L1 Green
PoE Green
P1 Yellow
Green
Flashing yellow
Yellow/green
Flashing green
R1 Yellow
Green
Flashing green
Green flashing
quickly
Green
3x fast,
1x long flashing
Flashing yellow
Yellow/green
F Red
Flashing red
Note
If the LED for the WLAN port is not green when the device starts up, although it is activated,
the port is not ready for operation (interface not initialized).
The main reason for this is usually that during commissioning of the SCALANCE W784-1xx /
W74x-1 products, a waiting time of up to 15 minutes can occur when the ambient
temperature is below zero. The device is ready for operation at the specified ambient
temperature as soon as the LED for the WLAN interface is lit green.
62
Meaning
Power supply over the 18 - 32 V DC connector.
Power supply using Power over Ethernet.
Data transfer over the Ethernet interface (traffic).
There is a connection over the Ethernet port. (Link).
PRESET-PLUG detected.
PRESET function completed successfully.
"Flashing" enabled over PST.
Data transfer over the WLAN interface.
W784-1xx in access point mode:
The WLAN interface is initialized and ready for operation.
W784-1xx in client mode or W74x-1:
There is a connection over the WLAN interface.
W784-1xx in access point mode:
The channels are being scanned.
W784-1xx in client mode or W74x-1:
The client is searching for a connection to an access point or ad hoc
network.
W784-1xx in access point mode:
With 802.11h, the channel is scanned for one minute for primary users
before the channel can be used for data traffic.
W784-1xx in client mode or W74x-1:
The client waits for the adopt MAC address due to the setting <Auto Find
Adopt MAC> and is connected to no access point.
W784-1xx in client mode or W74x-1:
The client waits for the adopt MAC address due to the setting <Auto Find
Adopt MAC> and is connected to an access point.
PRESET-PLUG detected.
PRESET function completed successfully.
An error occurred during operation with the device.
Ready to load firmware. The device was either stopped with the reset
button or there is incorrect firmware on the device.
SCALANCE W-784-1xx / SCALANCE W-74x-1
Operating Instructions (Compact), Release 08/2007, A5E01174713-02