Getting Started - CO/Tech ZB-0.07/8-XA4832-uk Bedienungsanleitung

Getting started

1. Attach the wheels to the pressure vessel and the air filter (2) to the compressor (see fig.).
2. If a transportation cover is fitted on the oil filler hole (5),
remove it and fit the proper cap.
3. Place the compressor in a dry and well
ventilated place.
4. Make sure that it is stable and cannot tip over.
5. Make sure that the oil level is up to the red circle in
the oil level window (4).
6. Connect the mains lead to a permanently installed
230 V wall socket.
Note:
Before using the compressor for the first time:
Open the drain tap (6) in the bottom of the pressure
vessel, switch the compressor on using the ON/OFF
button (9) and let it run for 10 minutes to lubricate all
the moving parts. Close the drain tap.
Use
1. Check the oil level in the window (4).
2. Attach a suitable air tool: blow gun, spray gun, tyre inflator, etc.
3. If necessary: Read the instruction manual of the connected air tool and set the recommended working
pressure using the regulator (10).
4. When you have finished work and the compressor has been switched off, the air should be released
manually by pulling out the safety valve (8).
• Use SAE 30 compressor oil at temperatures over +10 °C.
• Use SAE 10 compressor oil at temperatures under +10 °C.
Motor overload cut-out
If the safety cut-out has tripped, the motor has been overloaded in some way.
The button on the motor overload cut-out (1) will pop out a couple of millimetres when it
has been tripped and is reset by pushing it back in.
There are a number of possible reasons why the overload cut-out might trip such as
a voltage drop caused by the use of long extension leads, low ambient temperature
(under 10 °C), or that the pressure switch is not used to turn the compressor on/off in
the event of a power cut for example.
10 2
4
10 5