Engenius EP802 Handbuch Seite 10

24. Programmable Flash key timing
a. From MENU-6-2 to select flash key timing
b. 9-level (100 ms - 900 ms) timing selections, default= 600 ms.
c. The default value (600 ms) works in most areas. Changing this
setting may cause Flash key not working. Change only when you
are certain of the new value would work.
d. When entering the Base Settings, PIN is required. Default is "0000".
25. Assign next handset ID for new handset
a. Using registered handset from MENU-6-3 to assign a next handset
ID to a new handset.
b. If not assign next handset ID, the system will automatically assign a
handset ID to a new handset..
c. When entering the Base Settings, PIN is required. Default is "0000".
26. Clear Handset
a. Using registered handset from MENU-6-4 to remove the other
registered handset, in case the other registered handset is defected.
b. Once clear the other registered handset, the user is able to register a
new handset for instead.
c. When entering the Base Settings, PIN is required. Default is "0000".
27. Change PIN
Allow changing the base PIN which requires entering the "Base Settings"
(MENU-6-5).
a. Using registered handset to change PIN from MENU-6-5.
b. Default PIN is "0000".
c. When entering the Base Settings, PIN is required. Default is "0000".
28. Auto Hang Up feature
a. Using registered handset from MENU-6-6 to turn on/off the Auto
hand up feature.
b. If turning on the feature, the handset will automatically hang up the
call when the far-end hangs up the call.
c. When entering the Base Settings, PIN is required. Default is "0000".
29. Area Code
The area code function allows calls within local and country area codes
to be dialed without the prefix.
a. Enter MENU-4-7-1 to set the "Local" area code.
b. Enter MENU-4-7-2 to set the "Country" area code.
Re: Up to 3 digits can be entered.
~19~
30. Multiple Base setting
a. Up to 4 base stations can be set in one system.
Re: For best performance, maintain a distance of at least 5 meters
(about 15 feet) between any two base stations.
31. Set Time
The set time function allows user to set date/time to support the DTMF
caller ID (DTMF caller ID doesn't attach date/time when receiving from
PSTN, using this setting, user is able to review the date/time when the
caller ID received).
a. Enter MENU-6 to set Base Settings.
b. Press
or scrolling key to select desired base station when
Multi-Base is set.
c. Enter Base PIN (Default is "0000").
d. Enter "7" to enter Set Time.
e. Enter 4 digits for MM/DD(Month/Day), then enter 4 digits for hr:mm
(Hour：Minute)
f. Press SAVE (left soft key) to finish the setting.
32. Mic Gain
Allow changing the handset microphone gain based on the handset in
different environment – Quiet, Normal and Noisy environment.
This requires entering the "Phone Settings" (MENU-5-1).
33. Headset Ring
Allow changing the ringer emitted either from handset speaker or
receiver of headset.
This requires entering the "Phone Settings" (MENU-5-9).
34. Baby Monitor
Allow setting the handset monitoring the baby room via intercom call.
When setting Baby Monitor ON, this dedicated handset will not answer
any incoming call, except the 2-way intercom.
This requires entering the "Call Settings" (MENU-4-5).
~20~