Troubleshooting - Ryobi RLM4617SM Bedienungsanleitung

EN
FR DE ES IT PT
 If not using fuel stabilizer, allow the engine to run until
the mower is completely out of petrol.
 Once the engine has stopped, allow the blade to come
to a complete stop and disconnect the spark plug wire.
 Turn mower on its side (with carburetor facing up) and
clean grass clippings that have accumulated on the
underside of the mower deck.
 Wipe the mower clean with a dry cloth. Do not use a
garden hose or pressure washer to clean the mower.
 Check all nuts, bolts, knobs, screws, fasteners, etc.,
for tightness.
 Inspect moving parts for damage, breakage, and wear.
Have repairs made on any damaged or missing parts.
 Store the mower in a well-ventilated area that is clean,
dry, and out of the reach of children.
Problem
Handle not in correct Handle positioned incorrectly.
position.
Handle knobs not tightened.
Mower not starting. No spark.
No petrol.
Engine is fl ooded.
Starter rope pulls harder now than
when new.
Mower hard to push. High grass, rear of mower housing and
blade dragging in heavy grass, or cut-
ting height too low.
Wheel assembly needs cleaning.
Mower vibrating at Blade is unbalanced.
higher speed.
Bent motor shaft.
Mower not mulching Wet grass clippings sticking to the
properly underside of the deck.
Mower not bagging Cutting height set too low.
properly
RLM4617SM_RLM5219SME-23lgs.indd 21 RLM4617SM_RLM5219SME-23lgs.indd 21
NL SV DA NO FI HU CS RU
English
 Do not store near corrosive materials such as fertilizer
To lower the handle before storing (Fig. 14):
 Loosen the starter rope guide knob. Remove starter
 Fully loosen the handle knobs on the sides of the
 Push inward on each side of the lower handle, and lift
 Fold the lower handle forward, making sure not to bend

TROUBLESHOOTING

Possible Cause
21
RO PL SL HR ET
or rock salt.
rope from guide and allow to retract into engine.
handle and fold the upper handle down.
the sides of the lower handle past the edges of the
handle mounting brackets.
or kink the control cables.
Solution
Check to be sure that lower part of handle is pushed
fully back and snapped into proper position.
Tighten handle knobs.
Use spark tester to check for proper spark plug op-
eration.
Fill mower with petrol. If mower still does not start,
contact a servicing dealer.
Wait 15 minutes, then try starting mower again. Do not
prime before attempting to start.
Contact a servicing dealer.
Raise cutting height.
Clean wheel assembly. See Drive Gear Maintenance.
Replace blade.
Stop the engine, disconnect the spark plug wire from the
spark plug, and inspect for damage. Have repaired by
an authorized service center before restarting.
Wait until the grass dries before mowing.
Raise cutting height.
LT LV SK BG
2011/2/21 2011/2/21 2:15 2:15