Switching It On For The First Time; The Network Configuration Wizard - Noxon iRadio 300 Bedienungsanleitung

Switching it on for the first time

To start the NOXON, press the ON/OFF button on the NOXON itself marked with the
icon.
Setup wizard
Start now?
YES
Then, set the time format (12/24-hour).
The date and time follow. Set each of these using the navigation dial and confirm by
pressing the dial or the remote control. By the way, the date format is European – date
first, then month. Then, you can decide on a WLAN region. Unless you are currently in
Spain or France, [Most of Europe] is the correct choice for Europeans.
And that's all the information the setup wizard needs from you. It hands the baton over to
the network configuration wizard automatically.

The network configuration wizard

When switching it on for the first time, the NOXON network device does not yet have
any information about the possible network environments from which it will be getting its
content. After switching it on for the first time and selecting a language, the configuration
wizard will be displayed automatically.
As in all other menus of the NOXON, use the navigation dial to move through the selec-
tions. Confirm your selection by pressing the navigation dial.
The following chapter describes how to configure access, both for wired and wireless
network integration. If you are not satisfied with the way things are working after running
the Wizard, you can run it again by going to the main menu, selecting [Settings] and se-
lecting [Network] and then the network wizard in the following submenu.
After switching on the device, you enter the setup
wizard, which helps you set up your NOXON iRa-
dio.
NO
51