Type
Application
Reception range
LNB noise fi gure
Gain
Half power beam width
LNB
Switch-over
Low-Band
High-Band
Output frequency
Oscillator frequency
Figure of merit (G/T)
11.3/12.5 GHz
LNB supply voltage
Current drain, max.
Wind surface
Wind load
Clamping range
Weight
5. Important information
Before you begin to install, connect or utilise the antenna, observe the information you fi nd in these mounting
instructions.
If you fail to pay attention to the information, one cannot exclude:
• that due to wrong installation and connecting, or because of having modifi ed components or using foreign
components, the antenna or the mounting site can be damaged
• that because of inappropriate behaviour, risks for your and other people´s health and life will be created
• that the manufacturer will decline the liability for faulty function and resulted damages
It is most important that you are aware of the responsibility you have for your own and other people´s safety
when working on the antenna system.
Advice: Save these instructions for possible later use when questions come up.
In case you sell the antenna, hand over the instructions to the new owner.
GHz
dB
dB
°
kHz
kHz
MHz
GHz
dB/K
V
vertical: 11.5–14.0 – horizontal: 16.0–19.0
mA
m
2
N
(Wind velocity: 130 km/h) and elevation = 0°
For installation higher than 20 m above ground, the wind velocity
That corresponds to a wind velocity of 150 km/h.
mm
kg
BAS 62
For stationary use
10.70-12.75
Typ. 0.8
> 50
< 3 (at mid-band)
1 output switchable, H/V, high/low
0
22
950-1950/1100-2150
9.75/10.6
13.3/13.7
160
max. 0.25
240 at dynamic pressure of 800 N/m
must be multiplied with the factor 1.37.
38-60
6,9
2