Metz MECABLITZ 50 AF-1 digital Canon Bedienungsanleitung Seite 94

Setting procedure for remote slave flash mode
SL
SL
On
The setting takes effect immediately. After about 5 seconds the display stops
flashing and the setting is saved automatically. After activation of the remote
SL
slave mode, „ " appears in the display. In addition, the slave group (GROUP)
selected and the remote channel (CH) are shown.
Setting of the slave group
GROUP B
GROUP B
The setting takes effect immediately. After about 5 seconds the display stops
flashing and the setting is saved
automatically. After activation of the remote slave mode, „
display. In addition, the slave group (GROUP) selected and the remote channel
(CH) are shown.
94
• Press the button combination „Select" until
SL
„ " flashes in the display.
• Apply the setting desired with the buttons
+ and —.
– When „On" is displayed, the remote sla-
ve mode is activated.
– When „OFF" is displayed, the remote
slave mode is deactivated.
• With the remote slave mode activated,
press the button combination „Select" until
„GROUP" (= slave group) flashes in the
display.
• Apply the setting desired with the buttons
+ and —. Selection of group A, B or C is
possible.
SL
" appears in the
Setting of the remote channel
The same remote channel must be set on the slave flash unit as on the
master or controller flash unit!
• With the remote slave mode activated,
press the button combination „Select" until
„CH" (= remote channel) flashes in the
display.
• Apply the setting desired with the buttons + and —.
Selection of group 1, 2, 3 or 4 is possible.
The setting takes effect immediately.
After about 5 seconds the display stops flashing and the setting is saved auto-
matically. After activation of the remote slave mode, „
display. In addition, the slave group (GROUP) selected and the remote channel
(CH) are shown.
Testing remote flash mode
• Place the slave flash units in the desired positions for the shot. Use flash unit
mounting foot S60 (optional accessories, see 17) to set up the slave flash unit.
• Wait for all of the flash units involved to become flash ready. Once the slave
flash units are flash ready, the AF measuring beam
• Press the manual firing button
test flash. The slave flash units will respond in succession, according to slave
group, with a test flash. If a slave unit fails to fire a test flash, check the set-
tings for remote channel and slave group. Correct the position of the slave
flash unit so that it is able to receive light from the master flash unit via the
sensor .
The flash mode is transmitted automatically by master or controller.
When the flash unit functions as master in the cordless remote system,
the activation of the modelling light also activates the modelling light of
slave flash units
2
CH
CH
SL
" appears in the
will blink.
on the master or controller flash unit to fire a
2