Troubleshooting - AIPTEK PocketCinema V20 Handbuch

Troubleshooting

If your projector does not seem to be functioning properly, check the items below before you
contact an authorized service center.
Symptom
The projector can not be turned
on.
The projected image is too dark.
The projected image is dim.
The image is not played.
No image is projected when an
AV device is connected.
No image is projected when a
computer is connected.
18 18
Check Point
• Ensure the battery is loaded or the AC
power adapter is in use.
• Check if the battery is correctly
installed. Please refer to "Installing the
battery" on page 3.
• Use the projector in a darker
environment.
• Increase the brightness by using the AC
power adapter.
• Project the image on a flat, white
surface.
• Decrease the size of projected image.
• Adjust the focus. Please refer to
"Adjusting the Focus" on page 4.
• Check if the lens is dirty.
• Replace with an image of higher
resolution.
• Ensure the image format is compatible.
Please refer to the description of
supported formats on page 7.
• Replace with another file or memory
card.
• Convert the file with the attached AMC
software.
• Ensure the connected device is
equipped with AV-out function.
• Check if the AV Cable is connected,
and the projector is switched to AV-in
function.
• Check if the AV Cable is plugged
correctly.
• Check if the VGA Cable is plugged
correctly.
• Make sure the PC has been switched to
projector display.
• Ensure the display resolution of
PC screen is 640x680, 800x600 or
1024x768 as suggested.