Additional Information; Troubleshooting - Pioneer F-F6-J Bedienungsanleitung

07

Additional information

Chapter 7:
Additional information

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie in
another component. Investigate the other components and electrical appliances being used. If the
trouble cannot be rectified even after performing the checks listed below, ask your nearest Pioneer
authorized service center or your dealer to carry out repair work.
• If the unit does not operate normally due to external effects such as static electricity,
disconnect the power plug from the outlet and insert again to return to normal operating
conditions.
Problem
The power does not turn on.
No sound is output.
Can't operate the remote
control.
The display is dark or off.
Hissing or buzzing sounds are
heard during AM broadcasts.
(Noise from a TV or interference
in the signals sent from the
broadcast station.)
Booming sounds (humming) are
heard during AM broadcasts.
(Signals transmitted over the
power supply cord are
modulated by the power source
frequency.)
28
En
Remedy
• Disconnect the power plug from the outlet, and insert again.
• If you're trying to switch on using the remote control, make sure the
front panel POWER button is switched on first.
• If the power shuts off automatically, take the unit to your nearest
Pioneer authorized service center or your dealer for servicing.
• Turn the amplifier's power on.
• Make sure the amplifier is connected correctly (refer to Connections on
page 7).
• Press the MUTE button on your Pioneer amplifier to turn the muting off.
• Replace the battery (page 6).
• Operate within 7 m, 30° of the remote sensor on the front panel
(page 12).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• Press DIMMER on the remote repeatedly to return to the default.
• Turn off the TV.
• Change the position of the loop antenna.
• Install an outdoor antenna (page 27).
• Insert the plug in the opposite direction.
• Install an outdoor antenna (page 27).