Power Supply - Muse M-110 DB Benutzerhandbuch

GB DAB/DAB+ PORTABLE RADIO WITH BLUETOOTH
LOCATION AND DESCRIPTION OF CONTROLS
1. LCD display
2. Speaker
3. NFC tag
4. Standby
5. Bluetooth button
6. Menu/ Enter button
7. Reset/ Auto button
8. Info button
9. Station +/- button: Station up/down; setting up/ down
10. Volume +/- button: volume up/ down
ACCESSORIES
USB power supply adaptor x1
USB power cable x1

POWER SUPPLY

RIGHT VIEW
AC ADAPTOR
USB power supply adaptor
To DC in 5.5V jack
USB power cable
The supplied AC adaptor is suitable for use on AC main supplies of AC 100-240V
to a mains supply within these parameters.
Cautions:
• The AC adaptor included with this unit is for its use only. Do not use it with other equipment.
• Turn off the unit before unplugging the AC adaptor from the unit so as to avoid the unit being damaged.
• When the unit is not going to be used for long time, disconnect the AC adaptor from the AC outlet.
• Be sure to use it near the wall outlet and easily accessible. If a malfunction occurs, disconnect the plug from the wall
outlet at once.
R-3581 IB MUSE 001 REV3 - book.indd 5
11. DAB+/FM: Select DAB/DAB+ or FM band
12. Preset/ : preset the station in DAB/DAB+ or FM
mode; play/ pause in Bluetooth mode
13. button: previous channel; setting down
14. button: next channel; setting up
15. Carry handle
16. Earphone jack
17. Micro USB port (DC in)
18. FM telescopic antenna
19. Battery compartment
To AC outlet
50/60Hz and should only be connected
EN - 1
• AC adaptor is used as the disconnect device. It shall remain readily operable and should not be obstructed during
intended use. To be completely disconnected the apparatus from supply mains, the AC adaptor of the apparatus shall be
disconnected from the mains socket outlet completely.
• Never use an AC adaptor that is damaged, route power lead in a safe manner and make sure it is not subjected to trapping
or pinching. If the power lead is damaged refer to a qualified service agent.
Battery Operation:
1. Remove the battery compartment door by applying thumb pressure to area indicated on battery door and then lift the
door out and off the cabinet.
2. Before inserting the batteries, observe the polarities (+ and -) of the battery, then relate the polarities to the engraved
diagram inside the battery compartment, insert 4x 1.5V, R14/UM2/ "C" batteries (not supplied) into the compartment.
3. Replace the compartment door.
Before throwing any batteries away, consult your distributor who may be able to take them back for specific
recycling.
NOTES:
- Never recharge the batteries, apply heat to them or take them apart.
- In order to avoid leakage, always remove the batteries when unit will not be used for a long period of time.
- For optimal performance, alkaline batteries are recommended. These batteries must be replaced every six months.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
TURN ON/ OFF THE UNIT
In standby mode, press button to turn on the unit. Press this button again to turn off the unit.
TIME AND DATE SETTING
If connect the AC adaptor between the unit and AC outlet, or use batteries only, the time will blink, "Time is not set" will be
displayed. Then turn on the unit.
1. When the unit is on, press and hold Menu/ Enter button to enter into setting menu.
2. Rotate Station +/- button to select system mode, press Menu/Enter button to enter into system menu.
3. Rotate Station +/- button to select "Time" and press Menu/ Enter button again to enter into time setting mode.
Manual time and date setting
Under time setting mode, rotate Station +/- button to select "Set Time/ Date" and press Menu/Enter to confirm. Rotate
Station +/- to select the hour, minute, date value. Press Menu/ Enter button to confirm. "Time saved" will be displayed.
Noted: In 12 hour clock format, be sure to observe the AM/PM indicator to set the correctly.
Auto update
Under time setting system, rotate Station +/- button to select "Auto update" and press Menu/Enter to confirm. Rotate
Station+/- button to select the time auto update mode, press Menu/ Enter again to confirm.
Update from FM: time update from FM RDS.
Update from DAB: time update form DAB/DAB+.
Update from Any: time update from FM RDS or DAB/DAB+.
No update: show the time from system setting.
Set 12/24 hour format
Under time setting mode, rotate Station +/- button to select "SET 12/24 hour" and press Menu/Enter to confirm. Rotate
Station +/- button to select 12 or 24 hour format, press Menu/ Enter again to confirm.
Set date format
Under time setting system, rotate Station +/- button to select "SET date format" and press Menu/Enter to confirm. Rotate
Station +/- button to select your desire date format, press Menu/ Enter again to confirm.
MODE SELECTION
When the unit is on, press DAB+/FM button to select DAB/DAB+ or FM mode. Press Bluetooth button to select Bluetooth
mode.
VOLUME ADJUSTING
To increase or decrease the sound level, rotate Volume +/- button clockwise or anti-clockwise.
EN - 2
2015/4/7 9:07:49