Technical Data - AEG KRC 4338 Bedienungsanleitung

Recalling preset radio stations
1. Press the TIME SET button (5).
2. Choose the preset location with the SKIP+ (12) and SKIP-
(13) buttons.
Automatic station scan
When holding down the PROG button (11) for approx. 3 sec-
onds, the device will start the automatic station scan search-
ing the entire frequency range automatically for stations. The
stations found will be stored on the preset locations 1-20 in
ascending order.
NOTE:
The order cannot be changed once set.
Setting the Alarm Time (24 h)
(in Standby Mode)
You can set up to two alarms. As follows:
1. Hold down the ALARM1 or the ALARM2 button, (7/8) for
approx. 3 seconds. The hour indicator as well as AL1 or
AL2, will flash on the display.
• You can now adjust the settings for hours, minutes
and the buzzer successively with the SKIP+ (12) and
SKIP- (13) buttons. With regard to the alarm, you can
choose between buzzer (BU) and radio (FM).
BU = Upon reaching the alarm time, a buzzer will
sound. The volume will increase slowly.
FM = Upon reaching the alarm time, the last preset
radio station will sound.
• Confirm each entry with the ALARM1 or ALARM2
button. The setting to be adjusted will flash on the
display.
Snooze function
The automatic alarm can be switched off using the SNOOZE/
DIMMER button (15) for approx. 9 minutes.
Switch off the buzzer
In order to switch off the alarm until the following day please
press the STANDBY button.
Disabling the alarm
To disable the alarm completely, choose standby mode and
press the ALARM 1 or ALARM 2 button (7/8).
Delayed Shut-Off
You can use the function for delayed power-off with radio
operation. The unit is switched off automatically when the
selected time is reached.
• Select the time after which the unit is switched off by
repeatedly pressing the SLEEP button (10). The following
selections can be made: 60, 45, 30 and 15 minutes. SLEEP
OFF = function is disabled.
• This function can be cancelled with the STANDBY button
(4).
Cleaning
CAUTION:
Do not dip the appliance in water.
• Remove the plug before cleaning.
• Clean the appliance with a slightly humid cloth without
any additives.
Trouble-shooting
Symptoms Cause
The unit cannot The unit is
be operated. blocked and
"hangs".

Technical Data

Model: ................................................................................ KRC 4338
Power supply: .....................................................
Power consumption:...................................................................3 W
Protection class: ................................................................................II
Net weight: .............................................................................0.65 kg
Radio section
Frequency ranges: .......................UKW/FM 87,5 ~ 108 MHz
Subject to technical changes without prior notice!
This device has been tested according to all relevant current
CE guidelines, such as electromagnetic compatibility and low
voltage directives, and has been constructed in accordance
with the latest safety regulations.
English
27
Solution
Pull the mains plug for
approximately 5 seconds.
Then connect the unit
again.
220-240 V~, 50 Hz