Intended Use; Start-Up Of The Device/Introduction - AEG SR 4334 Bedienungsanleitung

ENGLISH
36
15 VOLUME MAX/MIN (volume control)
16 FUNCTION Function selector switch (OFF / CD / RADIO)
17 AUX IN connection
18 AC Mains connection
19 LED-display
20 POWER control lamp
21 FM ST. control lamp
22 Loudspeaker
23 Indicator lamp (memory)
24 Battery compartment
25 Indicator lamp (repeat)

Intended Use

This device is used for:
• The reception of radio programmes
• Playing back audio CDs
• Sound playback from external audio sources.
It is intended exclusively for this purpose and may only be
used as such. It may only be used in the manner described
in these instructions for use. The device must not be used
for commercial purposes.
Any other use of this device is considered to be contrary
to the intended use and may result in damage to materi-
als or even personal injury.
The firm ETV – Elektro-Technische Vertriebsgesellschaft
mbH does not accept any liability for damage caused as
a result of the use of this device contrary to its intended
use.

Start-up of the device/introduction

• Please read the operating instructions carefully before
using the device for the first time!
• Select a suitable location for the device, such as a dry,
flat, non-slip surface on which it is easy to operate the
machine.
• Ensure that the device is sufficiently ventilated!
• Remove the protective film from the display if it is still
present.
Power Supply
• Connect the power cable supplied (see battery com-
partment if necessary (24)) to a properly installed 230
V / 50 Hz safety power socket and the mains connector
AC ~ (18) on the back of the machine.
• Ensure that the voltage is the same as that indicated
on the model identification plate.
Inserting the Batteries (not supplied)
• Open the lid of the battery compartment (24) on the
bottom.
• Insert 6 batteries of type UM2/R14 1.5 V. Please ensure
that the polarity is correct (see the floor of the battery
compartment)!
• If the device is not used for a long period of time,
remove the batteries to avoid the spilling of battery
acid.
• Then close the battery lid.
NOTE:
When a mains cable is connected the batteries are
automatically switched off.
CAUTION:
• Different battery types or new and used batteries
must not be used together.
• Batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at the
relevant collection bin or at your dealer's.
WARNING:
Do not expose the batteries to high temperatures or
direct sunlight. Never throw batteries into the fire. There
is a danger of explosion!
Transport Safety Device, CD Compartment
• Open the CD compartment (3) by pulling the lid up-
wards by the tab (7).
• Before operating the machine for the first time,
remove the transport safety device from the CD player
if it is still in place.
Volume
The desired volume can be sent using the VOLUME
regulator (15).
Switch-off
The machine is switched off when the function selector
switch (16) is turned to the OFF position.The POWER (19)
control lamp goes off. Unplug the device.
AUX IN socket
To connect analogue replay devices. Via this socket you
can also hear the sound of other playback devices such as
MP3 players, CD players etc. through the loudspeakers.
1. Please connect the external device with a 3.5 mm
stereo jack plug to the AUX IN socket (17).
2. Set the function selector (16) to RADIO. The device
switches automatically to AUX IN operation. The radio
sound is switched off.
3. Through the loudspeakers you can hear the playback
of the sound from the external device; with the VOL-
UME control (15) you can change the volume. The CD
buttons do not have any function.
4. For the remaining procedure please see the operating
instructions of the external sound source.