Receiving A Call With Hands-Free; To The Factory Preset State - Panasonic SC-NT10 Bedienungsanleitung

Receiving a call with Hands-Free

If receiving a call on the mobile phone connected to this unit with Bluetooth
can make a hands-free call through this unit.
Preparation
For connecting Bluetooth
"One-Touch Connection (Connecting by NFC)" (
∫ Receiving a call
Press [ ] when this unit rings.
• When receiving the call, the Bluetooth
• Talk into the microphone (
∫ Ending the call
Press [ ].
Note
• Adjust the volume during a call with [VOL +] and [VOL -] on this unit.
• During a hands-free call, if you want to switch from this unit to the hands-free device, operate
the hands-free device.
• If this unit receives a call while playing audio with Bluetooth
ringtone automatically. In addition, during playback with the AUX IN jack, the audio of this unit
automatically changes to a ringtone of the pairing device.
• If you touch other devices to the NFC touch area of this unit when receiving a call, Bluetooth
connection will not switch.
• To mute the ringtone of this unit, press [VOL -] until the volume reaches minimum.
• Some apps for the mobile phone may not be available for hands-free.
To return to the factory preset state
Perform the following when you want to delete pairing device information, etc.
1 Press [Í/I] to turn the power on.
2 Press and hold [Í/I] for 10 seconds until Bluetooth
(blue) and Boost Mode indicator (orange) blink twice.
The pairing device information will be deleted by the reset, so it will be necessary to
perform pairing again. Delete the pairing information for this unit from the Bluetooth
device, then perform the pairing operation again. (See "Pairing with Bluetooth
7)
®
, refer to "Connecting via Bluetooth
®
indicator (blue) on the unit blinks.
4) on this unit.
®
menu" (
8).
®
, it changes the audio to a
®
®
, you
7) or
®
indicator
®
®
device"
11
11