Rear Speakers; Stands; Connecting To The Amplifier - aurum VIII Bedienungsanleitung

speaker that should be placed behind
and slightly above the typical listening
position.

Rear speakers

Whether you direct the rear speakers
toward the listening position is a matter
of taste. Also, many listeners prefer the
rear speakers to be positioned above
ear height. This can be achieved
by mounting the units on a sturdy
wall bracket, a high speaker stand, a
sideboard or shelf.
For optimal front and rear speaker setup, quadral has suitable stands in its product
range.
Should you have any questions, please contact us on tel.: +49 (0) 511 7904-0,
e-mail: ovs@quadral.com or info@aurumspeakers.com
Before connecting up the speakers to your hifi or surround sound system, please
ensure that the amplifier/receiver is switched off and its pilot light is not on. For
connection, you will need a twin-core loudspeaker cable for each speaker cabinet.
Make sure these cables are sufficiently long and cut them to a length that will
subsequently enable you to lay them behind furniture or under the carpet where
necessary. For cables more than 5 m in length we recommend a cross-section area
of at least 2.5 mm
enable optimum contact, about 10 mm of the cores at each end of the cable must
be isolated, and thus bare.
Screw terminals
For connection, the speakers are provided
with colour-coded screw terminals on the
back of the cabinet. Loosen the screw
terminals and feed the stripped end of
the core into the hole that is now free. The
two cores of speaker cables have different
colouring or shape for recognition. Connect
the "+" core to the red, positive terminal –
6
BDA AURUM komplett_08.2009.indd 6

Stands

Connecting to the amplifier

2
per core in order to avoid any unnecessary loss of output. To
> –
50 cm
FRONT
CENTER
SUBWOOFER
REAR
REAR
CENTER
REAR
25.08.09 10:46