Battery Installation; Radio Operation - Audiosonic CD-1589 Bedienungsanleitung

BATTERY POWER
Insert 8 x "C" size batteries into the battery compartment. Be sure that the batteries
are inserted correctly to avoid damage to the appliance. Always remove the batteries
when appliance will not be used for a long period of time, as this will cause leakage
to the batteries and subsequently damage to your set.
Notes:
• Use batteries of the same type. Never use different types of batteries together.
• To use the appliance with batteries, disconnect the AC power cord from it.

BATTERY INSTALLATION

Insert 2 x "AAA" size batteries into the battery compartment. Be sure that the batteries
are inserted correctly to avoid damage to the remote control. Always remove the
batteries when the remote control will not be used for a long period of time, as this
will cause leakage to the batteries and subsequently damage to your set.
Notes:
• Use batteries of the same type. Never use different types of batteries together.
• If the distance required between the remote control and the appliance decreases,
the batteries are exhausted. In this case replace the batteries with new one.
SENSOR WINDOW OF THE RECEIVER
• Even if the remote control is operated within the effective range, its operation may be
impossible if there are any obstacies between the appliance and the remote control.
• If the remote control is operated near other appliances which generate infrared
rays, or if other remote control devices using infrared rays are used near the
appliance, it may operate incorrectly.

RADIO OPERATION

AUTOMATIC TUNING
• Press the "FUNCTION" button to select "TUNER" mode.
• Press and hold the "SkIP +" or "SkIP -" button over 3 seconds to start automatic
6
tuning process.
Instruction Manual
• When a station is tuned in the tuning process, it will stop automatically and you
can listen to your desired station.
MANUAL TUNING
It is for selecting stations, which cannot be tuned automatically. (manual selection) To
tune a channel manually.
• Skip step 3 in the above procedures.
• In step 2, each time the "SkIP +" or "SkIP -" button is pressed momentarily (0.5
second or less), the frequency changes by a fixed step: FM: 0.1 MHz steps.
MEMORY PRESET
• Repeat step 1 to 3 in the AUTOMATIC TUNING procedures.
• Press the "MEMORY" button on the remote to start the preset process.
• Display will show the memory sequence number and a flashing "01".
• Press the "FOLDER +" or "FOLDER -" button on the remote to determine the preset
station number.
• Press again the "MEMORY" button on the remote to preset your desired station.
• Once all the stations were preset, press the "FOLDER +" or "FOLDER -" button on
the remote to listen to your desired station.
Notes:
FM can be stored up to 30 stations.
MONO / STEREO
• Press the "MONO / ST. " button to achieve the best frequency.
CD / MP3 OPERATION
GENERAL OPERATION
PLAY / PAUSE
Press to start playing CD / MP3 disc.
Press again to stop playing CD / MP3 operation temporarily.
Press again to resume playback.
SkIP +
Press to go to the next track or back to the previous track.