Configuring The Transistor Output Do1 To Switch A Load When A Warning Message Is Generated By The Device - bürkert 8025 universal Bedienungsanleitung

Type 8025 UNIVERSAL
Operatingandcommissioning
8.6.11 configuring the transistor output Do1 to switch a load
when a warning message is generated by the device
When the device generates a warning message, the device status LED is orange.
The generation of a warning message can also be indicated by the switching of the transistor output.
OUtPUt DO1
DO2
On a version WITH relay outputs
(see chap. 8.6.12 et 8.6.13.
FiLtER REtURN
On a version WITHOUT
relay outputs
Figure 41: Configuration of the DO1 transistor output to indicate the generation of a warning message
→
If you do not want to adjust another parameter, go to the "END" parameter of the Parameters menu and press
ENTER
to save the settings or not and go back to the Process level.
wARNiNG iNV YES
iNV NO
→
Choose the operating, inverted or not inverted, of the
transistor output.
→
Confirm.
0......9
English
49