Description of the washing
machine
Control panel
GB
Detergent dispenser drawer: used to dispense
detergents and washing additives (see Detergents
and laundry).
ON/OFF button
machine on or off. The START/PAUSE indicator light,
which flashes slowly in a green colour shows that the
machine is switched on. To switch off the washing
machine during the wash cycle, press and hold the
button for approximately 2 seconds; if the button is
pressed briefly or accidentally the machine will not
switch off. If the machine is switched off during a
wash cycle, this wash cycle will be cancelled.
WASH CYCLE SELECTOR buttons: used to set the
desired wash cycle (see "Table of wash cycles").
MEMORY button: press and hold the button to store
a cycle with your own set of preferences in the
memory of the machine. To recall a previously stored
cycle, press the MEMORY button.
FUNCTION buttons: press the button to select the
desired function. The corresponding indicator light on
the display will switch on.
SPIN button
: press to reduce or completely
exclude the spin cycle - the value is indicated on the
display.
TEMPERATURE button
temperature: the value will be shown on the display.
64
Detergent dispenser
drawer
SELECTOR
: press this briefly to switch the
: press to decrease the
CONTROL
ON/OFF
PANEL
button
LOCK
MEMORY
Button
WASH
CYCLE
DELAYED
Buttons
START
Button
CONTROL PANEL LOCK button
control panel lock, press and hold the button for
approximately 2 seconds. When the symbol
illuminated, the control panel is locked. This means it
is possible to prevent wash cycles from being modified
accidentally, especially where there are children in the
home. To deactivate the control panel lock, press
and hold the button for approximately 2 seconds.
DELAYED START button
start time for the selected wash cycle. The delay time
will be shown on the display.
START/PAUSE button with indicator light: when the
green indicator light flashes slowly, press the button to
start a wash cycle. Once the cycle has begun the
indicator light will remain lit in a fixed manner. To
pause the wash cycle, press the button again; the
indicator light will flash in an orange colour. If the
symbol
is not illuminated, the door may be
opened. To start the wash cycle from the point at
which it was interrupted, press the button again.
Standby mode
This washing machine, in compliance with new
energy saving regulations, is fitted with an automatic
standby system which is enabled after about 30
minutes if no activity is detected. Press the ON-OFF
button briefly and wait for the machine to start up
again.
SPIN SPEED
Button
Button
DISPLAY
START/
PAUSE
FUNCTION
button with
buttons
indicator light
TEMPERATURE
Button
: to activate the
: press to set a delayed
is