Installation; Electrical Requirements; Adjusting The Feet - Candy GO DC 78 Anleitung

40004848.qxd 01/12/2006

Installation

You may be
charged for a
service call if a
problem with
your machine is
caused by
incorrect
installation.
If the mains cord
on this appliance
is damaged, it
must be replaced
by a special cord
which is ONLY
obtainable from
the spares
service. It must
be installed by a
competent
person.
6
10:33 Page 6

Electrical requirements

Tumble dryers are supplied to operate at a voltage
of 230V, 50 Hz. Check that the supply circuit is rated
to at least 16A.
Electricity can be extremely dangerous.
This appliance must be earthed.
The socket outlet and the plug on the appliance
must be of the same type.
Do not use multiple adapters and/or extension
leads.
The plug should be accessible for disconnection
after the appliance has been installed.
The wires in the mains lead are coloured in
accordance with the following codes:
Blue
Brown
Green and Yellow
CE Appliance complies with European Directive
89/336/EEC, 73/23/EEC and subsequent amendments.
Do not plug the machine in and switch
it on at the mains until the installation
For your safety, this dryer must be
If there is any doubt about
installation, call GIAS Service for

Adjusting the feet

Once the machine is in place the feet should be
adjusted to ensure that the machine is level.
Adjust the four feet to ensure the machine is firm
and level.
NEUTRAL
LIVE
EARTH
is completed.
correctly installed.
advice.