125987521 ENGLISH.qxp
Drying
End of drying cycle
If the laundry is not removed at the end of the cycle, the dryer per-
forms an anti-creasing phase (duration: 30 minutes maximum).
If you do not remove the laundry, the dryer will stop automatically at
the end of the anti-creasing phase.
The "EINDE/FIN" and "FILTER/FILTRE" lights remain lit and the buzzer
sounds for 2 minutes.
The light of the "START/PAUZE-DEPART/PAUSE" button goes off and
a flashing zero appears on the display.
Switch the tumble dryer off
Turn the programme selector dial to "UIT/ARRET"; all the lights go out.
The appliance is switched off.
Remove the laundry.
If you open and then close the door before turning the program-
me selector dial to "UIT/ARRET", all the lights corresponding to the
phases making up the performed programme come on and the dis-
play shows the duration of the programme.
Important!
If the drying programme has to be stopped before it reaches the
end, we recommend that you turn the programme selector dial to
position "AFKOELEN/REFROID." and wait until the end of this phase
before removing the laundry. This will avoid a build-up of heat
inside the appliance. To do this first turn the dial to "UIT/ARRET"
and then to "AFKOELEN/REFROID." and depress "START/PAUZE-
DEPART/PAUSE" button.
Clean the filters
To ensure free circulation of air during the drying cycle, the fluff fil-
ters must be cleaned after each drying cycle, before removing the
laundry.
16
2007-05-23
09:51
Page 16