Maintaining The Appliance; Emptying The Dust Bin; Cleaning The Dust Bin; Cleaning The Brush Roller - SEVERIN HV 7158 Gebrauchsanleitung

HV7158.book Seite 20 Dienstag, 19. April 2016 10:28 10

Maintaining the appliance

Emptying the dust bin

4 Maintaining the appliance
The dust bin can only store a limited quantity of dirt.
Therefore, it is best to empty the dust bin after every cleaning procedure.
1. Make sure that the appliance is switched off and is not on charge.
2. Open the flap on the underside of the dust bin.
3. Empty the dust bin.
For further information, see also illustrated Quick Start Guide.

Cleaning the dust bin

1. Make sure that the appliance is switched off and is not on charge.
2. Unlatch, remove and empty the dust bin.
3. Remove any dust and dirt from the cyclone unit.
4. Open the flap for the motor protection filter at the top of the appliance.
5. Remove the motor protection filter.
6. Remove the foam ring from inside the motor protection filter.
7. Clean the motor protection filter with a soft brush.
8. Clean the foam ring under running water and then leave it to dry.
For further information, see also illustrated Quick Start Guide.

Cleaning the brush roller

Soiling may prevent the brush roller from rotating freely. Clean the brush roller regularly.
1. Make sure that the appliance is switched off and is not on charge.
2. Disconnect the floor nozzle from the suction tube.
3. Unfasten the stop catch for the brush.
4. Remove the stop catch.
5. Remove the brush.
6. Remove any hairs and dirt from the brush, carefully using tweezers or scissors as necessary.
For further information, see also illustrated Quick Start Guide.
20