Room Temperature Control - Dimplex VFMi C Montage- Und Gebrauchsanweisung

Operating Instructions for Users
Manual Charging (Manual Operation)
If the charging of the device is to be controlled manually, the
charging knob must be placed on the axis of the adjuster.
Remove the cap at the front panel of the storage heater.
The thermal energy to be stored can be set via the knob.
On extremely cold days choose setting III (right-hand stop),
with higher external temperatures choose a lower setting.
No charging takes place at the left-hand stop.
Maximum charging

Room Temperature Control

The transfer of the thermal energy stored in the storage
heater is automatically controlled via the room temperature
controller. The desired temperature, e.g. 20° C is set on a
scale. Room temperature controllers can be either wall-
mounted or integrated into the storage heater.
During the night or when a room is not used, the temperature
should be lowered by roughly 4° C.
A further lowering of the temperature is not recommended,
as this causes excessive cooling of the room's walls. In case
of changes of the temperature settings, it will take a while for
the room temperature to be reached.
temperature lowering must be cancelled some time (at least
one hour) before the room is to be used again. With many
controllers this can be carried out automatically with a
setback thermostat.
During longer absences frost protection must be taken into
consideration.
Maintenance
Occasional vacuum-cleaning in the area of the air outlet grid
and the lower slot rows of the right side panel is
recommended.
As part of the maintenance cycle, it is recommended to test
the correct functioning of the controlling and regulating
devices. This test must be carried out every 10 years at the
latest to prevent unnecessary energy consumption.
12
No charging
Therefore, the
Temperature Management
Room Too Cold
• Check the breaker/fuses for the storage heaters in the
supply panel and, if necessary, replace or reactivate the
breaker/fuses.
• Charging adjuster at the storage heater set too low
(manual charging only). Correct setting.
• Incorrect room thermostat setting. Correct setting.
• The windows and doors are open and/or the neighbouring
rooms are not heated.
• Incorrect setting of the central charge control.
Correction according to the operating instructions of the
charge control.
Room Too Hot
• Check the breaker/fuse for the charge control in the
supply panel and, if necessary, replace or reactivate the
breaker/fuse.
• Charging adjuster at the storage heater set too high
(manual charging only). Correct setting.
• Incorrect room thermostat setting. Correct setting.
• Incorrect central charge control setting:
Correction according to the operating instructions of the
charge control.
If you cannot correct the fault, please contact an electrician
or your nearest after-sales service provider.
To process your order, we require the model number (E-No.)
and the data code (FD). This information is listed on the
rating plate.
Rating plate
English