Burmeier ROYAL Gebrauchsanweisung Seite 62

62
Trouble-shooting table aid
Problem Possible causes
Hand switch/
central drive unit system
plugged in
not functioning
connected
hand switch
box
power failure the hand switch
changes to locked status)
unit system is defective
Drives only operates for a
short time when buttons
are pressed
Function LED on hand
switch not lit or lit continu-
ously when button is pres-
sed
Individual Drives operate
in one direction only
central drive unit system defective
The wrong function is
active when hand switch
incorrectly connected (mixed up)
buttons are pressed
Motor drives stopped
suddenly after a long time
unit system is triggered on
of adjustments
Continuous or longer
lasting signal without using
defective
hand switch
G
EBRAUCHSANWEISUNG
Solutions
Main power cable is not
Wall socket defective
Hand switch plug not properly
Functions are blocked on
Drives locked at the locking
Hand switch locked (after
hand switch with magnet key
Hand switch or central drive
necessary repairs
Too much weight on the bed
Bed is blocked by an obstacle
Defective drive
necessary repairs
Drive is at end position
Locking function is activated
Load limit exceede
Hand switch, drive motor or
necessary repairs
Internal motor plugs
necessary repairs
Thermo switch in central drive
rements (see page 29)
Central drive unit system is
necessary repairs
P ROYAL · I
FLEGEBETT NSTRUCTION
Insert main power cable
Check wall socket/fuse box
Check connector plugs
Unlock functions (see page 32)
Unlock knob at locking box
Change locked status on the
Inform your operator about
Reduce load
Remove obstacle
Inform your operator about
Remove drive from end position
Unlock locking box
Reduce load
Inform your operator about
Inform your operator about
Observe minimum pause requi-
Inform your operator about
M N B ROYAL
ANUAL FOR URSING ED