Removing / Inserting The Battery; Recharging The Battery; Used Batteries; Checking The Battery Charge Level - Parkside PABSW 10.8 B2 Originalbetriebsanleitung

GB
charging times would be a waste
of energy. Excessive charging will
void the warranty.
• Charge the battery before the first
time of use. Do not briefly charge
the battery several time in a row.
• Recharge the battery when you no-
tice that the appliance is becoming
slower.
• If a fully recharged battery lasts
for considerably shorter operating
times, the battery is used up and
needs to be replaced. Only use an
OEM spare battery available from
our Customer Service.
• Always take heed of the applicable
safety instructions as well as the en-
vironmental protection regulations
and information.
• The warranty excludes all defects
caused by improper handling.
Removing / inserting the
battery
1. To remove the battery (
the appliance, press the release
button (
pull out the battery.
2. To insert the battery (
it on the guide track (20) and
push it back into the appliance.
It will audibly snap in.

Recharging the battery

1. Remove the battery (
the appliance.
2. Inser the battery (
charging compartment of the bat-
tery charger (
bly snap in.
12
6) from
7) on the battery and
6), place
6) from
6) in the
13). It will audi-
3. Plug the battery charger (
into a mains outlet.
4. When the battery is fully re-
charged unplug the battery
charger (
5. Pull the battery (
battery charger (
Green LED flashes
Red LED lights up
Green LED lights up
Battery such alleged charged
Green and red LED flashing
Green and Red LED light up
Battery is too hot or too cold

Used batteries

• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to be
replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information (see "Cleaning and Main-
tenance").
Checking the battery charge
level
The battery's ( 8) charge level is indicat-
ed by the charge state indicator (
Press the activation button battery indicator
on the battery.
The LEDs indicate the battery's charge
level.
13)
13) from the mains.
6)out of the
13).
Charger ready
Battery charging
Defective battery
6).