Hama 173160 Bedienungsanleitung Seite 5

Note – Connection to a new
device
• If you want to connect a new
terminal device to the
Bluetooth
®
speaker, press and hold the
function button (6) for approximately
3 seconds until the status LED (8)
begins to flash blue and an acoustic
signal sounds.
• The current connection is
disconnected and the search for new
terminal devices starts.
• The speaker always stores the last
eight terminal devices paired.
• The speaker will automatically
connect to the last terminal device
paired when it is switched on the
next time.
4.5 Automatic Bluetooth
(after successful pairing)
• Make sure that your Bluetooth
terminal device is on and Bluetooth
activated.
• Make sure that the speaker is located within
the Bluetooth
range of max. 10 metres.
®
• Switch on the speaker as described in 4.1
Switching the product on and off.
• After successful connection, the status LED
(8) will light up in blue. An acoustic signal
confirms that connection was successful.
Note – Connection impaired
After the speaker and terminal device
have been paired, a connection
is established automatically. If
the Bluetooth
connection is not
®
established automatically, check the
following:
• Check the Bluetooth
of your terminal device to see
whether
PowerBrick
If not, repeat the steps listed under
Bluetooth
pairing.
®
• Check whether your terminal device
and the speaker are less than 10
metres apart. If not, move them
closer together.
► ||
(
connection
®
-capable
®
is
®
settings
®
is connected.
• Check whether obstacles are
impairing the range. If so, move the
devices closer together.
• Check whether the audio cable is
connected to the speaker. If so,
disconnect it.
4.6 Audio playback (via Bluetooth
Start and control audio playback on the
connected terminal device accordingly.
Alternatively, audio playback can also be
controlled on the speaker (if the connected
device supports this function).
• Press the ► || ( function button (6) to start
or pause audio playback.
• Briefly press the function button + (5) to
increase the volume.
• Briefly press the function button – (7) to
reduce the volume.
• Press and hold the + function button (5) to
jump forward one title.
• Press and hold the – function button (7) to
jump backward one title.
4.7 Hands-free function
You can use the speaker as a hands-free set
for your mobile phone. For this function,
the mobile phone must be connected to the
speaker via Bluetooth
• Press the function button ► || ( (6) once to
answer an incoming call.
• Press and hold the function button ► || (
(6) for approx. 2 seconds to reject an
incoming call.
• You can put a call on hold by pressing and
holding the ► || ( function button (6) for
approximately 2 seconds.
• Press and hold the ► || ( function button (6)
again to continue the call.
• During a call, press the function button
► || ( (6) once to end the call.
Note – Call quality
To increase the call quality, make sure
that you are near the speaker with your
mobile phone during the call.
.
®
)
®