Ecler DP 300 Bedienungsanleitung Seite 35

Now press the PREVIOUS key and the audio source selection will appear. Leave this setting in its
default selection, OUT 1- INA and OUT 2-INB
OUT 1&2
Srce IN a & IN B
Press the PREVIOUS key and the gain screen appears. Leave this setting at 0,0dB gain.
On the following press of the PREVIOUS key, the limiter screen appears. The default value is +4dBV.
Change this value to +0,4 to give a little emphasis to this band without causing too much signal level.
Should you want a stronger limiting, please set up the threshold here. In this example this is not the
case.
As explained in the above paragraphs, pressing PREVIOUS brings you to the configuration of the delay
and delay link parameters. Leave this parameters in their default settings (delay = 0,000ms, Delay Link
= Off).
Next, leave the Polarity setting in Normal position.
At this point, the filter characteristics screens appear consecutively.
The desired filter has a Linkwitz-Riley characteristic with lower and upper cut-off frequencies of 15Hz
and 164Hz.
Press the PREVIOUS key to access the Lo Shape parameter. Chose the "L-R 24" option, i.e. Linkwitz-
Riley filter with 24 dB/oct slope.
OUT 1&2
Lo Shape
Press PREVIOUS again, so that the screen where the lower cut-off frequency can be adjusted, shows
up. Turn the encoder or use the ? and ? keys and adjust 15Hz.
OUT 1&2
Hi pass
Press the PREVIOUS key to access the Hi Shape parameter. Chose the "L-R 24" option, i.e. Linkwitz-
Riley filter with 24 dB/oct slope.
OUT 1&2
Hi Shape
Low
Low
L-R 24
Low
15.0Hz
Low
L-R 24
35