Derailleur Hanger; Shock; General Recommendation M4-M8; Compatibility Check - PROPAIN TYEE Bedienungsanleitung

12

Derailleur hanger

The derailleur hanger needs to be tightened using 6 Nm / 4,42 ft lb.
The rear X-12 axle needs to be tightened using 10-16 Nm / 7,38-
11,8 ft lb.

Shock

The M8 bolt screws of the shock need to be tightened using 18 Nm
/ 13,28 ft lb.

General recommendation M4-M8

You can find general recommendations in the following
table in case there are no other instructions on spare
parts. Propain also recommends using Loctite 243 (me-
dium) to secure those screws.
Size of the screw
M4
M5
M6
M8
i
Tightening torque
3 Nm / 2,21 ft lb
6 Nm / 4,42 ft lb
9 Nm / 6,64 ft lb
18 Nm / 13,28 ft lb
Shock
The Tyee frame is compatible with most of the shocks available on
the market (with the correct length and travel). Nevertheless, there
are exemptions which is why Propain always recommends a check
of compatibility when installing a new shock into the bike.

Compatibility check

When installing another shock into the bike, you have to make sure
it is compatible with the frame. The most important point is to check
the specifications of the new shock.
It needs to have the following specifications:
Shock length:
Shock travel:
Shock hardware:
Mounting bolts:
If the specifications are identical, the shock can be installed into the
bike to check if there are any points of contact when riding the bike.
Points of contact could damage the bike severely, which in the worst
case could lead to a crack in the frame and / or a crash when riding
the bike.
EN
210mm
55mm
50mm, Tyee All-Mountain
20mm (top), 30mm (bottom)
M8