Hama VM-10xl Bedienungsanleitung Seite 9

Using
You can connect:
- A single A/V Distribution Amplifier VM-10xl
- Several A/V Distribution Amplifier VM-10xl units to increase the number of outputs
Connecting a A/V Distribution Amplifier VM-10xl
You can connect a single A/V Distribution Amplifier VM-10xl unit as a 1:10 video audio DA, in which audio is
unbalanced stereo audio (left and right) or balanced mono audio (+ and -).
To connect the A/V Distribution Amplifier VM-10xl as a 1:10 video unbalanced stereo audio DA, do the following:
1. Connect a video audio source (for example, a composite VCR) to the VIDEO IN BNC connector and to the
left and right AUDIO IN RCA connectors.
2. Connect the 10 VIDEO OUT BNC connectors and the 10 left and right AUDIO OUTPUT RCA connectors
to the video audio acceptors 1 to 10.
3. Connect the power cord to the mains electricity.
4. Push in the Term button to terminate the line to 75 .
5. Release the BAL/ST button to select unbalanced stereo audio operation.
6. Adjust the video trimmer controls for output signal level and/or cable compensation equalization level, if
required.
7. If audio control adjustment is required for left and/or right gain, push in Enable/Disable button, and then
adjust the trimmer controls.
9