Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting; General - Jacobsen 67945 – LF 3400 5 Gang 2WD Handbuch

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

5 Troubleshooting

5.1

GENERAL ________________________________________________________________

The troubleshootijng chart below lists basic problems that may occur during start-up and operation. For more detailed
information regarding the hydraulic and electrical systems contact your area Jacobsen Dealer.
Symptoms
Engine will not start.
Engine hard to start
or runs poorly.
Engine stops.
Engine overheating
Battery not holding
charge.
Battery light on.
Reels cut unevenly
Possible Causes
1.
Parking brake disengaged, traction
pedal not in neutral or mow switch on.
2.
Glow plug has not timed out.
3.
Battery low on charge or defective.
4.
Fuel tank empty or dirty.
5.
Fuse blown.
6.
Relay defective
7.
Neutral switch on traction pedal out of
adjustment or defective.
1.
Fuel level low, fuel or fuel filter dirty.
2.
Air cleaner dirty.
3.
Injectors, fuel pump
4.
Engine problem.
1.
Fuel tank empty.
2.
Interlocks not set before leaving
operator's seat.
1.
Coolant level low.
2.
Air intake restricted.
3.
Water pump belt broken or loose.
1.
Loose or corroded battery terminals.
2.
Low electrolyte.
3.
Alternator belt loose or broken.
4.
Charging system defective.
1.
Bedknife-to-reel not adjusted correctly.
2.
Engine speed too low.
3.
Mow speed not adjusted for turf
conditions.
4.
Mow switch set in reverse.
5.
Not enough rear roller pressure.
6.
Front roller not following undulations
adequately
TROUBLESHOOTING
Action
1.
Check interlock system and start-up procedure.
2.
Reset ignition switch and allow glow plug to time out
before cranking engine.
3.
Inspect condition of battery and battery connections.
4.
Fill with fresh fuel. Change fuel filter. Bleed fuel
lines.
5.
Replace fuse.
6.
Test and replace relay.
7.
Adjust or replace switch.
1.
Fill with fresh fuel. Change fuel filter. Bleed fuel lines.
2.
Inspect and replace air filter.
3.
Consult engine manual.
4.
Consult engine manual
1.
Fill with fresh fuel and bleed fuel lines.
2.
Engage parking brake and set mow switch to OFF.
1.
Inspect and add coolant.
2.
Clean air intake at radiator.
3.
Tighten or replace belt.
1.
Inspect and clean terminals
2.
Refill to correct level.
3.
Tighten or replace belt
4.
See engine manual
Inspect bedknife-to-reel adjustment.
Check engine speed. Run engine at full throttle.
Adjust mow speed for best cut.
Set for forward rotation.
Move down pressure spring one hole towards spring.
Move down pressure spring one hole away from spring
5
GB-21

Werbung

Kapitel

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis