Multiplex 30 8562 Bedienungsanleitung Seite 37

POWER PEAK® TRIPLE 360 W EQ-BID
EXPLAINING STORE MODE (JUST FOR LITHIUM BATTERY)
the "MODE" button. With this mode, Lithium batteries can be "winterised" and maintained at
a preset voltage. The battery parameters should be carefully set up.
The cut-off voltage has been set as follows:
LiPo: approx.. 3.85 V / cell
LiFe: approx. 3.45 V / cell
LiIo: approx. 3.75 V / cell
Depending upon the voltage state of the battery connected, it will be automatically charged
or discharged until the cut-off voltage has been achieved.
Note: For safety reasons, one should always connect the battery voltage sensor lead
to the charger!
SELECTING A MEMORY LOCATION
SELECTING THE TYPE OF BATTERY
SETTING UP NUMBER OF CELLS/BATTERY VOLTAGE
The following voltages are available to use for lithium batteries:
LiPo
Cell count Battery voltage
1 3,7 Volt
2 7.4 Volt
3 11.1 Volt
4 14,8 Volt
5 18,5 Volt
6 22,2 Volt
Operating instructions
Selecting a memory position between 0 and 9.
The battery types NiCd, NiMH, LiPo, LiIo, LiFe or PB
(lead) can be selected in this menu.
Here the number of cells can only be selected bet-
ween 1 and 14 cells for NC and NiMH battery packs.
With the battery types LiPo, LiIo, LiFe and Pb (lead-
acid) you should enter the nominal battery voltage
instead of the cell count.
LiIo
Cell count Battery voltage
1 3,6 Volt
2 7,2 Volt
3 10,8 Volt
4 14,4 Volt
5 18,0 Volt
6 21,6 Volt
13
37
# 30 8562
LiFe
Cell count Battery voltage
1 3,3 Volt
2 6.6 Volt
3 9,9 Volt
4 13,2 Volt
5 16,5 Volt
6 19.8 Volt