Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATION
Baby Unit
1.
Adjust the microphone sensitivity switch
transmit whenever the microphone
2.
Using the Power/Channel selector
8
indicator
lights up steady green and will blink green whenever the batteries become run
down. In such case charge up the batteries using the supplied charger stand.
3.
The transmit indicator
4.
Place the unit about 1 m from the crib with the microphone
5.
The unit will return to standby mode a few seconds after the microphone
any sound and the transmit indicator
6.
The Night Light
9
be varied by turning the knob.
Parent unit
1.
Set the Channel selector
2.
Turn the Volume control
3.
Place the parent unit at a reasonable distance away from the baby unit to avoid feedback. Too
close a distance will create a screeching sound at the speaker
4.
The LCD will show the baby sleeping icon.
5.
Whenever a voice is received, the LCD will show the baby crying icons alternately. This
moving graphic is useful to alert the parents in case the volume is turned down to keep the
environment quiet.
6.
If the parent unit is beyond the communication range of baby unit for over 2 minutes an
Out-of-range alarm will be heard and the Out-of-range icon
parents. The alarm will go off only when the parent unit falls back within communication range
of baby unit.
7.
If the batteries become run down, the battery icon
battery warning alarm will also be heard. Recharge the battery using the supplied charger
stand.
NB. This alarm will also be heard in case the baby unit switched off or its battery has un down
or its power is cut off.
8.
Every time the unit receives a voice or sounds an alarm the LCD will be back lighted
automatically to show the icons in dark environment.
9.
Both baby unit and parent unit can be carried around using the belt clip
for convenience. To remove belt clip follow the diagram as shown.
PRECAUTIONS
•
Use only the supplied switching power supply. Use of other adapters may cause damage to
the baby monitor.
•
When not using the monitor for long period of time, remove all batteries from the units to avoid
damage due to battery leakage.
•
Disconnect the AC switching power supply from the wall outlet when the monitor is not to be
operated.
•
The BC-966 baby monitor is best performed within a temperature range of 5°C to +45°C .
•
Do not leave the monitor expose to strong sunlight for a long time or nearby any heat source,
moisture and excessive dusty environment.
•
Do not open the cabinet, no serviceable part inside.
4
2
7
will light up once the unit is in transmit mode.
7
can be switched on using Night Light On/Off switch
10
to the same channel as the baby unit.
to switch on the unit.
11
to either Hi or Lo such that the unit will be set to
5
picks up a sound at your desirable loudness level.
switch on the unit to either Channel 1 or 2. The Power
will go off.
will blink rapidly in the LCD and a low
4
facing towards the baby.
stops picking up
4
3
. It's brightness can
.
12
start blinking ta alert the
Werbung
Inhaltsverzeichnis
