Bernina BERNETTE 10 Bedienungsanleitung Seite 78

15
EN Sewing on buttons
Move the drop feed control to right side to
lower the feed dogs. (1)
Change presser foot to button sewing foot.
Turn the stitch length dial to "0".
Position the work under the foot. Place the
button in the desired position, lower the
foot. Set the pattern selector knob on zigzag
stitch. Adjust the stitch width between "3"
-"5" according to the distance between the
two holes of the button. Turn the handwheel
to check that the needle goes cleanly into
the left and right holes of the button. Set the
pattern selector knob on straight stitch, and
sew a few securing stitches. Set the pattern
selector knob on zigzag stitch, and slowly
sew on the button with about 10 stitches. Set
the pattern selector knob on straight stitch,
and sew a few securing stitches.
If a shank is required, place a darning
needle on top of the button and sew. (3) For
buttons with 4 holes, sew through the front
two holes first (2), push work forward and
then sew through the back two holes(3).
Move the drop feed control to left side for
normal use.
502020.75.24_021V4D0101_1010_IM_bernette 10 12 15_EN_DE_NL_FR