Hitachi CP-X10000 Bedienungsanleitung Seite 145

PJLink command
PJLink command PJLink command
This projector is equipped with the PJLink
See the following table for the commands for controlling the projector using the
TM
PJLink protocol are as given in the table below.
Commands
POWR
POWR ? Power Status inquiry
INPT Input Source selection
INPT ?
AVMT
AVMT ?
ERST ?
6
Control Description
Power Contorol
Input Source inquiry
AV Mute
AV Mute inquiry
Error Status inquiry
TM Class 1.
Parameter or Response
0 = Standby
1 = Power On
0 = Standby
1 = Power On
2 = Cool Down
11 = COMPUTER IN 1
12 = COMPUTER IN 2
13 = BNC
21 = COMPONENT
22 = S-VIDEO
23 = VIDEO 1
24 = VIDEO 2
31 = HDMI
32 = DVI-D
11 = COMPUTER IN 1
12 = COMPUTER IN 2
13 = BNC
21 = COMPONENT
22 = S-VIDEO
23 = VIDEO 1
24 = VIDEO 2
31 = HDMI
32 = DVI-D
30 = BLANK off
31 = BLANK on
30 = BLANK off
31 = BLANK on
1st byte: Refers to Fan error; one of 0 to 2
2nd byte: Refers to Lamp error; one of 0 to 2
3rd byte: Refers to Temptrature error; one of 0 to 2
4th byte: Refers to Cover error; one of 0 to 2
5th byte: Refers to Filter error; one of 0 to 2
6th byte: Refers to Other error; one of 0 to 2
The mearning of 0 to 2 is as given below
0 = Error is not detected; 1 = Warning; 2 = Error