Overheating Protection - DS Produkte Z 03040 Gebrauchsanleitung

EN
Quick Drying of the Hair
Use the device without attachments.
5. Switch on the device on the highest blower setting.
6. Select the temperature setting or .
7. Dry your hair evenly.
8. Finish off on temperature setting and cool down your hair for a short while.
Smoothing the Hair
5. Start off by drying your hair without an attachment: Switch on the device on the high-
est blower setting and select the temperature setting or .
6. When the hair is just slightly damp, switch off the device.
7. Plug the hair-styling nozzle onto the air outlet opening. It must engage audibly.
8. Switch on the device on a low blower setting and a high temperature setting.
9. You should now blow-dry each strand individually using a brush until smooth.
10. Finish off on temperature setting and cool down your hair.
Styling
5. Plug the hair-styling nozzle onto the air outlet opening. It must engage audibly.
6. Switch on the device on a low blower setting and a high temperature setting.
7. Shape each strand individually, e.g. using a round brush, and blow-dry it as you do
so.
8. Once you have shaped a strand to the style you want, press the
and fi x the strand in place with cold air.
Styling Curls and Waves
5. Plug the diffuser attachment onto the air outlet opening. It must engage audibly.
6. Switch on the device on a low blower setting and a high temperature setting.
7a. With short to medium-length hair guide the diffuser over the head in small circular
movements. Proceed section by section here.
7b. Long hair should fi rst be dried at the tips by placing sections of it on your fi ngers.
Then guide each individual section towards your head with the diffuser and leave it
there for a while. Move the diffuser over your scalp in small circular movements.
8. Fix the sections of hair in place with cold air by pressing the
switching over to temperature setting .

Overheating Protection

The device is equipped with an overheating protection feature that switches off the de-
vice when there is overloading, e.g. if the air outlet or intake opening is covered with fl uff
and hair.
1. If the device stops working during operation, switch it off and remove the plug from
the plug socket.
2. Check whether the air outlet or intake opening is blocked. If this is the case, remove
the blockages (see the "After Use" chapter).
3. Wait for 5 to 10 minutes before you connect the device to the mains power again and
switch it on.
16
❆ cool shot button
❆ cool shot button or