Technical Data; Installation - Zanussi ZBF11420SA Benutzerhandbuch

Problem
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".

Technical data

Dimension of the recess
Rising Time
Voltage
Frequency
The technical information are situated in the rating plate
on the internal left side of the appliance and in the energy
label.

Installation

Caution! Read the "Safety Information" carefully for
your safety and correct operation of the appliance
before installing the appliance.
Positioning
Install this appliance at a location where the ambient tem-
perature corresponds to the climate class indicated on the
rating plate of the appliance:
Climate
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
8
Possible cause
The door is not closed correctly.
The temperature regulator is not set
correctly.
Height
Width
Depth
Ambient temperature
Refer to "Closing the door".
Set a higher temperature.
3. If necessary, replace the defective door gaskets.
Contact the Service Center.
880 mm
560 mm
550 mm
20 h
230-240 V
50 Hz
Electrical connection
Before plugging in, ensure that the voltage and frequency
shown on the rating plate correspond to your domestic
power supply.
The appliance must be earthed. The power supply cable
plug is provided with a contact for this purpose. If the do-
mestic power supply socket is not earthed, connect the
appliance to a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
Solution