Screw Mounting - eQ-3 MAX! Wandthermostat+ Bedienungsanleitung

• Remove the protective film from the adhesive strip.
• Press the assembled MAX! Wall Thermostat + with the
back side to the wall in the position where it should sub-
sequently be attached.

Screw mounting:

• Choose a site for installation.
Make sure that electrical lines in the wall will not be
damaged.
• Position the mounting plate on the desired site on the
wall. Make sure that the arrow on the mounting plate is
pointing upwards.
• Use a pen to mark the positions of 2 bore holes A (dia-
gonally opposite) in the mounting plate on the wall. The
bore holes B can be used for installation with a flush-
mounting box.
A
• If you are working with a stone wall, drill the marked two
5 mm holes and insert the plugs supplied. If you are wor-
king with a wooden wall, you can pre-drill 1.5 mm holes
to make screws easier to insert.
40
B
B
A