Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Compass measurement mode
- In normal time or measurement mode, press D key to enter compass measurement mode (COMP). With
COMP displayed, electronic needle will sweep two circles clockwise and then enter the compass measu-
rement mode. It will measure in the first 30 seconds and lock up in the last 30 seconds. It will return to clock
mode automatically if no keystroke is done.
- In compass correction mode, press and hold A key for 2 seconds to enter correction selection mode. Press
B key to change the following:
Digital correction mode:
- In digital correction mode, press E or C key to set direction "W" or "E". After confirm the direction, press B
key to select azimuth angle value sequentially. Press E key to set the value with 1 increment. Press C key
to adjust the value with 1 descending.
- The maximum correction angle range is ±45° W" "E"±45°.
- Press A key to confirm the corrected value, and return to normal measurement mode.
Auto correction mode:
- In auto correction mode, press E or C key, then turn the watch slowly, both clockwise and anti-clockwise
are ok. This watch will exit the correction mode automatically and return to compass measurement mode
after simply turning two circles in the same direction. During compass correction, after 60 direction points
illuminate and go out one by one sequentially, it will confirm this correction automatically. Note: (After repla-
cing the battery, this watch will enter into automatically correction mode firstly by using the compass first
time. In order to correct the compass conveniently, please turning two circles according to the above
method. )
23
Werbung
