Displays; Customer Display; Drawer Lock Key - Sharp XE-A113 Bedienungsanleitung

5

Displays

Operator display
PLU/SUB
DEPT REPEAT
RCPT
OFF
Amount: Appears in the far-right eight (max.) positions. When the amount is negative, the minus symbol "-"
appears before the amount.
Number of repeats for repetitive registrations:
The number of repeats is displayed, starting at "2" and incremental with each repeat. When you
have registered ten times, the display will show "0."(2 → 3 ..... 9 → 0 → 1 → 2 ... )
Receipt function status:
The indicator "_" appears in the RCPT OFF position when the receipt function is in the OFF
status.
Time: Appears in the second to sixth positions (using 24-hour format) in the OP X/Z, REG or MGR
mode. In the REG or MGR mode, press the
Machine state symbols
: Appears during programming.
: Appears with an error code when an error is detected. For the details of error codes, please refer to
"Error code table" on page 31.
: Appears when the subtotal is displayed or when the amount tendered is smaller than the sales amount.
: Appears when the
: Appears when a transaction is finalized by pressing the
: Appears when the change due amount is displayed.
: Appears in the far-left three positions at the timing of key entry when the electronic journal (EJ) memory
is full. (Depending on programming.)
: Appears when the voltage of the installed batteries is under the required level. You must replace with
new ones within two days. Refer to page 76 for details.
: Appears when the batteries are not installed, or the installed batteries are dead. You must replace with
new ones immediately. Refer to page 76 for details.
: May appear right below the eighth and ninth places at the timing of finalization of a transaction when the
electronic journal (EJ) memory is nearly full.
Also appears right below the tenth place when power save mode is effective.
: Appears when programmed date (and time) for EURO modification operation has come.
: Appears when the print roller arm is not locked.
: Appears when the paper is not set or out.
6

Drawer Lock Key

This key locks and unlocks the drawer. To lock it, turn 90 degrees counterclockwise. To unlock it, turn 90
degrees clockwise.
Clerk code
DC SHIFT NUMBER
V
key is pressed to calculate a subtotal in foreign currency.
1
QUICK START GUIDE
Part

Customer display

(Pop-up type)
s
key to display the time.
A X Y
, , ,
2
Part
c b
or key.
3
Part
7