ACME Boomerang GT Anleitung Seite 9

3) Install the rudder unit into the connector above the elevator unit and fix it with the screws.
4) Connect the rudder plastic linkage of the rudder and elevator. Then insert carbon pipe to one side of the
main wing.
5) Insert the carbon pipe to the other side of the main wing and put them together as shown. Then connect
the servos of both wings with a "Y" cable.
6) Connect the wings with the wooden plate and fix it with the four screws. Pair the inner servos with
brackets flaps and do the same with outer servos and brackets ailerons. Connect the wire of the servo to the
corresponding port of the receiver and take care of the polarity.
Boomerang Globe Traveller