Switching Off The Device - Pierenkemper PierenStim Parese Gebrauchsanweisung

Pierenkemper Operating Manual - PierenStim Parese

Switching off the device

Press the key to switch off the device. If the battery
level has fallen below a critical value or outside the
stimulation no button has been depressed for a period
of two minutes, the device switches off automatically. An
acoustic signal is then transmitted.
Program editing
The parameters for programs 1-6 can be changed.
Use the editing mode for this purpose. The new User
Programs are named U1 to U6.
Starting the editing mode
Press the key and the
the editing mode. This is only possible if the device is not
locked (refer to chapter "program locking"). The active
editing function is shown on the down, right corner of
the display with an E symbol.
42
key simultaneously to enter
Select the program to be changed with the
Then press the key to start changing the parameters.
Press the key at any time to interrupt the editing
procedure. No program is then changed.
Editing the impulse width
The first parameter to be edited is the pulse width.
Choose a value between 10 ms and 2 s. Change the pulse
width in steps of 100 ms with the left-hand
keys. Change the pulse width in steps of 10 ms with the
right-hand and keys.
key.
and