Smeg KSEV910X1 Montage- Und Gebrauchsanweisung Seite 24

2. Replace the damaged light bulb.
Only use halogen bulbs of 20W max (G4), making
sure you do not touch them with your hands.
3. Close the lamp cover (it will snap shut).
For models shown in Fig. 1J + Fig. 4J:
1. Use a small screwdriver as a lever on the borders of
the lamp in order to remove the lightbulb.
2. Slide out the lightbulb to be replaced and replace with
a new 12V 20W 30° Ø35 12V GU4 PHILIPS
STANDARD LINE code 425409.
3. Carry out the replacement and mount the new
lightbulb by following instructions in the reverse.
For models shown in Fig. 1G + Fig. 5G:
Dismount the chimneys: remove the two screws (20 a)
that attaches the upper chimney to the support „G"
(Fig. 16).
Remove the box „q": remove the screw „r" that
secures the cooker hood.
Remove the lamp housing „s": remove the screws „t"
that position the housing in the lamp housing area.
Extract the damaged lamp.
Use only PHILIPS type 14515 (GX 5.3) 12V - 75W
halogen bulbs..
Reposition and secure the lamp housing „s" and the
box „q" and remount the chimneys.
For models shown in Fig. 1K + Fig. 4K:
Certain versions of this cooker hood provide for an
incandescent lamp at 40W maximum (E14), remove
the lamp cover to access the lamp housing and carry
out any replacements.
Only for the illustrated model in Fig. 1L + Fig. 6L:
1. Open the front panel "v" upwards, which holds the
lamp in place, ensuring to hold the lamp "z" with one
hand.
2. Replace the damaged lamp with one of identical
technical characteristics.
Attention! To guarantee the equivalent quality of
lighting, it is recommended to use the same type of
lamp bulb:
Philips neon Lamp
8711500644305.
Ensure that the transparent part of the lamp bulb is
facing inwards so as to guarantee correct light
distribution.
3. Replacing the starter:
Use a starter with identical technical characteristics.
Recommended starter: Use a Philips S10 starter.
4. Remount the lamp housing and the front panel in the
inverse in relation to the dismounting.
Only for the models illustrated in Fig. 1M + Fig. 7M:
1. Remove the grease filters.
2. Remove the ceiling light unscrewing the 3 screws that
fix it to the hood (hold the ceiling light to prevent it
falling).
3. Change the damaged bulb with one with identical
technical characteristics.
Changing the starter
Use a starter with identical technical characteristics.
bulb 13W Code Ref.
Starter advised: use a Phillips S10 starter.
4. Remount the ceiling light and the grease filters in the
reverse manner to the montage.
If the lights do not work, make sure that the lamps are fitted
properly into their housings before you call for technical
assistance.
24