Herunterladen Inhalt Inhalt Diese Seite drucken

LaserLiner DuraMax Bedienungsanleitung Seite 20

Vorschau ausblenden Andere Handbücher für DuraMax:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
DuraMax
Preparing the calibration check:
It is possible for you to check the calibration of the laser. To do this, position
the device midway between 2 walls, which must be at least 5 metres apart.
Switch the device on. The best calibration results are achieved if the device is
mounted on a tripod. Switch on the device and determine the marking
points with the SensoCommander. To do this, set the SensoCommander Pro
to the fine adjustment range.
1. Mark point A1 on the wall. (Use spot mode.)
2. Turn the device through 180° and mark point A2. You now have a hori-
zontal reference between points A1 and A2.
1.
A1
2.
A1
Performing the calibration check:
3. Position the device as near as possible to the wall at the height of point
A1. Now adjust the device in the X axis.
4. Turn the device through 180° and mark point A3. The difference between
points A2 and A3 is the tolerance for the X axis.
5. To check the Y axis, repeat steps 3 and 4.
3.
A1
4.
180°
180°
Note: If points A2 and A3 are more than 1 mm / 10 m apart on either the
X or Y axis, the device is in need of calibration. Contact your
authorised dealer or else the UMAREX-LASERLINER Service Department.
20
180°
180°
ENGLISH
A2
A2
A2
A3
A2
A3

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis