Conformity Declaration - Rupes BA225S Original Bedienungsanleitung

TOOL IDENTIFICATION PLATE
POSITION AND MEANING OF INFORMATION
1. Type of tool.
2. Nominal working voltage in Volts (V).
3. Working frequency in Hertz (Hz).
4. Absorbed current in Amperes (A). Ensure that the power supply to which the tool is
connected can easily tolerate the indicated current as a minimum.
5. Absorbed power expressed in Watts (W).
6. Tool code or serial number.
7. Technical data of the tool.
8. Maximum rpm
9. The double square indicates that the tool is doubly insulated and therefore does not
require earthing through the power supply cable.
10. Read all these instructions before operating this product and save these
instructions.
11. Personal safety devices.
12. At the end of its useful life, the product, pursuant to European Directive 2002/96/CE
(RAEE) + 2003/108/CE and its implementation in national law, must not be released
into the environment or thrown away as domestic waste, but must be disposed of at
authorised recycling centres (contact the relevant local authorities for a list of places
where the product may be disposed of according to the law).Disposing of the product
correctly contributes to protecting human health and safeguarding the environment.
Any illegitimate disposal of the product will be punishable by law.

CONFORMITY DECLARATION

We declare on our responsability that the hand-held motor operated tool, which is
mentioned in the present operating manual, is in comformity with the Essential
Requirements of Safety of the following Directives:
2006/42/CE Machinery
2006/95/CE Low Tension
2004/108/CE Electromagnetic Compatibility
2011/65/CE RoHS
The tests have been carried out in accordance with following Standards:
EN 60745-1: 2010
EN 60745-2-3: 2011
EN 55014-1: 2006 + A1: 2009 + A2: 2011
EN 55014-2: 1997 + A1: 2001 + A2: 2008
EN 61000-3 -2: 2006 + A1: 2009 + A2: 2009
EN 61000-3-3: 2008
EN 62233 : 2008
Technical file at:
RUPES S.p.A.
Via Marconi, 3A
20080 VERMEZZO (Mi) - Italy
Vermezzo (MI), 03/02/2014
S.p.A
IL PRESIDENTE
G. Valentini
11