Overload Protection - Bosch AXT 2000 HP Bedienungsanleitung

F016 L70 438 - book.book Seite 3 Dienstag, 28. Februar 2006 3:26 15
Starting and Stopping
2
The rotational direction switch 3 must be turned to
the right. The feed intake 1 must be empty.
Starting:
Set the on/off switch 2 to "I".
Stopping:
Set the on/off switch 2 to "O".
The motor will coast after switching off!
Rotational direction switch
The rotational direction switch 3 can only be oper-
ated when the machine is switched off. Always wait
for the machine to stop before switching it on again.
Right position ( ):
The spiral cutting knives pull in the material and
shreds it.
Left position ( ):
The spiral cutting knives are operating in reverse di-
rection and jammed material is released.
Longer material standing out from the ma-
chine could lash out when being pulled in
by the knives! Please keep at safe distance!

Overload Protection

Overloading (e. g. blocking up of the spiral cutting
knives) causes the machine to stop after a few sec-
onds. After a short period, the machine can be
switched on again. If the machine blocks turn off. Set
the On/Off switch 2 to "O", then wait a few seconds
and turn it back to "I".
If the blockage does not clear, turn the rotational di-
rection switch 3 to the left position (
the machine on to release the blockage. If the block-
age does not clear, repeat.
After the blockage has released, turn the On/Off
switch 2 to "O" and the rotational direction switch 3
to the right position ( ) before switching the ma-
chine on again.
Restart Protection
After a mains failure the machine cannot restart on it
own when the power returns.
11 • F016 L70 438 • 06.02
Working Instructions
3
1
Always wear eye protection and wear gloves
during use.
In order to collect the shredded material, fasten the
carrying straps of the collecting bag 7 (accessory) to
the two hooks 9.
Feed the material to be shredded. The material is
pulled in by the spiral cutting knives.
Longer material standing out from the ma-
chine could lash out when being pulled in
by the knives! Please keep at safe distance!
Only insert as much material so that the feed in-
take 1 will not be blocked up.
Shred withered, moist material and garden waste
which has been stored for some days alternately
with branches. This prevents the cutter from clog-
ging and helps to mix the material for composting.
Do not fill soft waste such as kitchen rubbish into the
shredder but compost directly.
Always feed the material to be shredded from the
corner of the feed intake 1 marked with the arrow.
Take care that the shredded material can fall freely
from the discharge chute 8 – danger of backing up!
The ventilation slots 5 must not be covered by the
collecting bag or the shredded material.
Advice on Shredding
Branches become harder to shred depending on the
type, age and dryness of the wood.
For best results, shred fresh branches soon after
) and switch
they have been cut.
Soft garden waste should be shredded in smaller
loads, particularly when wet. Any blockages can be
avoided by intermittently shredding branches.
English - 3