Monitoring Your Baby; Adjusting Loudspeaker Volume - Philips SBC SC477 DECT Bedienungsanleitung

ENGLISH
8
1 Position the Baby Unit at least one metre away from your baby.
2 Set the MONITOR/INTERCOM power on switch (8) on the Baby Unit to
3 Switch on the Parent Unit by pressing the POWER button (18).
LEVEL
SYSTEM
POWER
1 Set the Single Point Control mode switch (19) on the Parent Unit to
2 Press the Single Point Control +/- button (20) on the Parent Unit to
3 Set the volume/sensitivity selection switch (19) on the Parent Unit to
4 Press the Single Point Control +/- button (20) on the Parent Unit to

Monitoring your baby

Switching on the units
Never place the Baby Unit inside the baby 's bed or playpen.
MONITOR.
> The DECT system check light (5) blinks (green).
> The DECT system check light (14) blinks (green).
> DECT system check lights of Baby Unit and Parent Unit light continuously
(green) when both units have established a connection.
Note:The Parent Unit beeps when it is (accidentally) switched off.

Adjusting loudspeaker volume

Parent Unit
PARENT VOL.
increase/decrease the loudspeaker volume of the Parent Unit.
> The sound-level lights (12) on the Parent Unit give visual feedback about
the setting for approximately 3 seconds.
0 lights = monitoring baby silently
5 lights = maximum
Note: A high pitched noise may occur in case the units are too close to each
other. To avoid this you should set the Parent Unit volume to 0 before
placing the units close to each other.
Baby Unit
BABY VOL.
increase/decrease the loudspeaker volume of the Baby Unit.
> The sound-level lights (12) on the Parent Unit give visual feedback about
the setting for approximately 3 seconds.
0 lights = speaker off
5 lights = maximum
Note:You can only change the Baby Unit volume if the connection between the
Baby Unit and Parent Unit is established.