Storage; Transport; Care And Maintenance; Maintenance Intervals - Kärcher HG 43 Bedienungsanleitung

 Remove the high-pressure hose from
the high-pressure input.
 Pull main plug out of socket with dry
hands only.
Storing the Appliance
 Insert the trigger gun in the holder on
the frame together with the spray lance.
 Roll up high pressure hose and electri-
cal conduit and hang them into the re-
spective holders.
Note: Do not twist high pressure hose and
electrical conduit.
For longer work breaks or if a frost free stor-
age is not possible:
 Drain water.
 Flush device with anti-freeze agent.
(See "Care and maintenance".)
CAUTION
Risk of personal injury or damage! Consid-
er the weight of the appliance when storing
it.

Transport

ATTENTION
Protect the trigger from damage during
transport.
CAUTION
Risk of personal injury or damage! Mind the
weight of the appliance during transport.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.

Care and maintenance

DANGER
Risk of injury by inadvertent start-up of ap-
pliance and electric shock. Prior to all work
on the appliance, switch off the appliance
and pull the power plug.
 Switch the device off (see "Operation").
 Allow device to cool down.
Your Kärcher vender will inform you
about the performance of a periodic
safety inspection resp. signing of a
maintenance contract.
16
Shutdown

Storage

Maintenance intervals

Weekly
 Check fuel sieve, clean if necessary.
 Check fuel pre-filter, clean if necessary.
 Check fuel filter, clean if necessary.
Monthly
 Check sieve in the water shortage safe
guard, clean if necessary.
Every 500 operating hours, at least
annually
 Decalcify appliance.
 Have the maintenance of the device
performed by the customer service.
Maintenance Works
Cold water high-pressure cleaner
Carry out maintenance work on the cold
water high-pressure cleaner as directed in
the manufacturer's operating instructions.
Clean the fuel sieve
 Knock the dirt off of the fuel sieve. Do
not let the fuel enter the environment.
Cleaning fuel pre-filter
 Pull the rubber cover out of the fuel
tank.
 Clean fuel pre-filter.
 Reinsert the rubber cover.
Cleaning fuel filter
 Dismantle the fuel filter.
 Clean fuel filter.
 Reassemble the fuel filter.
Clean sieve in the water shortage safe
guard
 Remove the fastening clamp and pull
out the hose (soft damping system).
 Take out sieve.
Note: If necessary turn in screw M8 appr. 5
mm inwards and therewith pull out sieve.
 Clean sieve in water.
 Push sieve inwards.
 Slide the hose adapter all the way into
the lack of water fuse and secure it with
a fastening clamp.
– 5
EN