Stardom SOHORAID SR2-SB3+ Bedienungsanleitung Seite 5

6. Always safely dismount the volume from the Operating System before removing SOHORAID SR2 from
host computer.
7. Do not remove the hard drive(s) while the system is powered on or switch the position of the drives.
Always remember to power off the unit prior to removing the hard drives (unless hot-swapping for the
purpose of a rebuild in a RAID 1 configuration).
8. In RAID 1 mode, only 1 hard disk failure is permitted. Please seek help from data recovery services
should there be further data-loss due to failures in a RAID 0 mode.
9. It is highly recommended for users to back up important data. Stardom will not be responsible for any
lost of data caused during the use of the unit or the recovery of the data lost.
10. The default setting of SOHORAID SR2 is RAID 1. To set it in a data protection mode, please set it to
RAID 1. Please set SR2 to RAID 0 mode when speed and large storage capacity is required.
11. Users can set the RAID level and the basic functions of SOHORAID SR2 using the buttons on the
right side of LCD screen in front of the product.
4. Hardware Installation
Please follow the instructions below to complete the hardware installation:
Step 1 Open the package and take out the product making sure that all contents are not damaged or
missing. Should you find any damage or missing contents, please contact your supplier
immediately.
Step 2 Place the system on a stable surface. Ensure that it is installed in a well ventilated area with
acceptable airflow for the vent and keep product away from moisture.
Step 3 Use the provided key in the accessory kit to eject the removable tray, pull tray handle to remove
! !
from SR2.
! !
! !
!
Step 4 Install your hard drives onto the removable drive tray and secure it with the screws included in the
accessory kit. Once completed, insert the hard drive tray into the system.
! !
SOHORAID SR2 Series User Manual
ESC ALARM
ENT MUTE
! !
! !
! !
!
5
E S
C
A L
A R
E N M
T
M U
T E